This is the COMPANION version, not the Smart Control
Make sure you have the correct model! See pics for assistance
Optional Installation service Level 2
No data sold or shared. NO SPAM!
Sent by Letter Mail - No Tracking
90-day money back guarantee
USD
$ Indicates prices are in USD
New button dome array for Logitech Harmony Companion
Old buttons can be removed by using a hair dryer to warm the adhesive and it should peel right off.
CLEAN the gold bullseye pads on the circuit board with isopropyl alcohol. 90%+ is best
Place the new dome array over the board. This is NOT adhesive and is held in place by the housing when reassembled
You might also like
My remote works again
The replacement part arrived in two and a half weeks in a simple envelope—along with assembly instructions—but was well-protected (foam sheet, protective sleeve, and paper).
There were no customs duties or VAT to pay; I don't think the package was inspected.
You just need to take your time and be careful. It’s a job well within the capabilities of a DIYer.
My Companion remote is working again, and I’m very happy because I can't find a reasonably priced equivalent these days.
The domes seem a bit noisier than the originals, but that might just be because they're new. And even if they don't last as long as the originals, replacing them will be easier in the future (since they aren't glued down).
I’m very pleased and want to thank ButtonWorx, as I couldn't find this replacement part anywhere else.