Logitech Harmony Remote Button Repair Membrane

Put-In-Place Full Keypad Repair for ALL the buttons 

Includes New Snap Domes

The ButtonWorx™ membrane keypad permanently fixes the buttons by inserting a new keypad between the original buttons and the circuit board. New electrical contacts that never wear out like the rubber keypads do and it blocks any oil or dirt from causing problems in the future.

• • Crazy simple installation! 
• • Carbon film that never wears out
• • New GOLD snap domes
• • No Paint or glue that would chip and flake off
• • Tested for over 1 million button presses with no sign of wear

This version is the complete button replacement. No Deoxit needed to clean the old metal switch contacts. The GOLD version keypad replaces the old white sticker layer and also refurbishes all the rubber button switches. 

To install the GOLD version ButtonWorx™ repair you do need to remove the old snap domes held down by a white sticker. Warm it up with a hairdryer to make it peel off easier. The circuit board needs to be cleaned with isopropyl. I like to use a damp q-tip and give each button contact a good rubbing. That is easier once the sticker is removed. Just don't get Isopropyl near the LCD screen. It can't break it but it does get under the backlight and make the display look weird. If there is any adhesive left behind after removing the old domes, please clean that up so it doesn't find it's way into your new ButtonWorx™ buttons. 

Compare the versions All are put in place. No peel and stick, these are not stickers.

Top: Repairs the buttons around the LCD only. You cannot later get just the lower buttons. In the future if you want to repair the other buttons a complete new keypad membrane would need to be ordered. 

Full: Repairs all the rubber switch buttons. This does not include repairing the metal dome switches. The metal dome switches typically last much longer than rubber contact switches.  Metal dome switches can be cleaned (after pulling up the sticker holding them down) 

Gold: Repairs all the buttons. Like the Full version, all the rubber switches are repaired with ButtonWorx™ membrane and it also includes new gold plated metal dome switches. For this version you do need to remove the old metal domes and the white sticker holding them down. Just warm it with a hair dryer and peel it off. Some rare versions have the domes built into a loose sheet much like the ButtonWorx™ which does not stick down and the Gold version would simply replace that part of the original remote.