TEMPUR PEDIC
TEMPUR-Ergo

HSC-TP-RF-TAES

100003-RFREMS-L008

Remote Control Membrane Keypad Repair Pad 

Do-It-Yourself

• Permanent Repair
• PUT-IN-PLACE Easy Installation
• No paint ink or glue
• Will not chip or flake off
• Tested over 1 Million button presses!
• Blocks dirt and oils forever
• NOTE: Requires Torx T8 screwdriver to open remote 

Options

• Professional Installation
  For when your buttons have slowly become hard to use over time
  Send in your remote for a good cleaning and keypad repair
  (Shipping is for returning after service)
  
  
• Repair Service
  For more serious problems, battery leak corrosion, dead remotes, etc...
  (You must mail your remote in for repair)

Permanently repairs rubber keypad buttons by adding a new layer of conductive material.

Your buttons fails when the conductive pad wears out and silicone oils seep from the keypad. This gooey paste blocks electrical conductivity and stops the switch from working.
The ButtonWorx membrane keypad blocks dirt and oil from reaching the circuit board and offers a new conductor that cannot break down like rubber conductors do. 

Note: This is for repairing hard to press buttons. If all your buttons stopped working one day, then the remote is broken (not the buttons) and needs repair 

Our membrane keypads are custom cut for each model.

IMPORTANT: CLEAN THE CIRCUIT BOARD WITH ISOPROPYL ALCOHOL

Install the ButtonWorx™ repair membrane FLAT FLAT FLAT. There is no need to make sure it is stuck down. 
Do Not press down on the button areas. That can cause buttons to cave in creating a permanent short circuit. 
Just place it down using the holes for alignment. If it needs to be repositioned you can remove it and try again.